Powerflush Services London & SURROUNDING AREAS
Rated 4.9 Out of 5.0

1000+ Satisfied Customer

DIY Powerflush: Is it Possible?

January 14, 2018

DIY Powerflush: Is it Possible?

The sludge build-up can cause a problem on your central heating system. This issue prevents proper water circulation all over the system. It also causes premature failure and potential damage to your boiler. The most effective way of removing the sludge without causing harm to the system is a power flush.
A power flush is a process that requires a specialised equipment. However, a DIY power flush is possible when your system comes with a detachable filter fitter. This do-it-yourself task is not as successful as the correct power flush. But, it effectively eliminates a reasonable amount of slush and enhances the efficiency of your system.
Your central heating system attracts the magnetic particles accumulated in the system water. These particles stop the system from working efficiently. The black sludge that you can see in the heating systems has metal particles from the steel & iron radiators, causing restrictions. The magnet in the center of the filter attracts these particles, and they attach to the spindle.
Follow these steps to get started with DIY power flush:
  • Check the volume of the filtered sludge before you carry out a DIY power flushing. It’s best if you inspect and clean the filter months before a power flush.

  • Cleanse the filter and have it refitted.

  • Begin with a DIY power flush. Follow these steps:

  • Power off the radiators except one. Set this in full settings.

  • Put the heating to its high level so it will never go off while being tested. Set the room’s temperature to the greatest.

  • Leave it on for at least fifteen minutes. It makes your central heating system work through its single radiator. Therefore, it will concentrate the energy through this.

  • After fifteen minutes, power off completely the radiator in use. After that, power on another radiator and set it to its full limit.

  • Repeat the procedure in turn for every radiator until all the radiators have had fifteen minutes of allocated time each from the system.

  • Power off the heating.

  • Check its filter again and find out the amount of sludge accumulated within.

  • A filter can accumulate another six grams of mud during a DIY power flush. While it is not a big issue, still the amount of sludge accumulated is the same as how much is collected in two months of central heating system use. When you perform a similar process on the CH system that was never flushed and drained for years, there is more dirt to clean. This process would not give all the advantages of a professional, efficient power flush. It will also be a great way of minimisng slush together with the system inhibitor extracts.

The best thing to know about DIY power flushing is that it’s a low-cost and simple process. With the given set of steps here in this page, you can effectively clean your central heating system on your own without difficulties. Get started today and reap the same benefits with professional power flush.